Power down all others.
Connect the Energy Meter to the ccgx with an USB to RS485 cable (see our price list).
After rider selecting a meter, see its detailed settings: There are 3 options recovery to connect multiple Energy Meters: Each wired to a separate RS485-USB converter.
2 martensen meters wired on to one RS485-USB converter.Set it.If you don't do this, the Zigbee to RS485 converter may be connected permanently to another Zigbee device.The joystick on the right software manual side on the display, above the front selector).Press the joystick right registration several times until 'Address' appears.Now you can adjust the address by pressing the joystick up and down.This will allow it to be automatically configured by the rest of the system patch the meter.Press down again twice.And in the gray box at the right side it shows the configured function.Press the joystick down until until the display shows 'Pass'.Note the jumper between terminals window 1 and.The RS485 to USB interface cable between the ccgx and the Energy Meter can be extended up to 100 meters; make sure that the extensions patch of the Data (orange) and Data- (yellow) wires under form a twisted pair.Measure the output of a AC Genset (deprecated) Grid meter, used as control input for.This document is i-sensys the manual for the EM24 three manual phase max 65 A per phase Energy Meter.Besides adding an extra worms sensor, it is also possible, in a single phase installation, to use the, unused, second phase to measure the output of the PV Inverter.The display now shows measurements again.Hub-4 system, the meter is connected to the Color image Control.Note that this model is not stocked by Victron Energy, we recommend to purchase it locally.Other EM24 models from Carlo Gavazzi can also be used, as the communication is the same.Note that only one extra Energy meter can be added: the systems works only with address 1 (the default) and. A few seconds after connecting, the active LED should be on and the TX/RX LED should be blinking (the converter takes its power from the ccgx, so the ccgx needs to be switched on as well).
RS485 Converter, energy meter, yellow, terminal.